Have some more questions before i do the thing.
1) Do you turn the motor to your reference satelitte before or after you put the dish on the motor. i.e do you wait until after you have the dish on the motor, to use the reciever to turn your motor to your reference satelitte?
2) I have read up on rawlbolts, and they say if you do not put into middle of brick, it is not as good. If you have pebble dash, how do you guys get around this. i.e When your installing and they have pebble dash, and you use rawlbolts, do you just drill and not care about where in the brick it ends up?
3) Anyone just use normal rawlplug bolts, like some sites advise. Are they just as good?
4) I am going with 2 k's and 1 t, brackets. What would be the best way to place these, and how far apart should they be placed for best effect, to take the strain?
5) With the lnb skew on your reference sat. Do i put the dish into position, onto my reference site, then make the lnb vertical(6 o'clock). Or do i put the lmb vertical at start and then move the dish to my ref sat?
Hope those questions are clear for you guys to undertsand, Thx for your help in advance. |