The factory reset put the STB settings of all the sats back to default.
You can see from the first picture how the motor is fixed.
The rope affair was my method of raising the Dish/motor assembly and is subject of another post.
I did put in my coords,
The pole and TK Brackets are fixed with M10's and is solid.
The pole is 100% upright.
The dish is centered on the motor arm.
There is some backlash on the motor which when moved does not give a signal. I will adjust this backlash as soon as I find out how.
I sent the dish to 28e via USALS and changed the dish elevation and rotation on the pole to peak the signal. Then sent the dish to 1w, and am getting no signal from Thor.
I have set the elevation on the motor to my coord of 52.5 but the dish elevation scale when receiving signals from 1w is nothing like?
You can see from the second picture that the triax dish is locked by two bolts and slides, as opposed to pivoting for elevation of the dish. Not as easy as my smaller dish which pivots on one bolt.
There is no index mark for the dish scale, but I assume it must be the center point?
Should the scales on both the motor and dish be set at 52.5N |