Chip face down id correct but if you are using CCcam 2.1.0 you must use the CCcam.cfg that goes with it.
In the latest cfg at the very bottom you will need to sellect the correct seca handler.
Thanks to willow on Nabilo for saving me the time to find this
# The seca handler is used to better support simulcrypt on the same ident
#
# With this setting you can change the behaviour of how SECA has to be used
# This setting is ignored unless SECA2/SECA3 simulcrypt is detected!!
#
# When disabled CCcam behaves like previous versions
#
# When "prefer SECA3 over SECA2" is enabled try to use SECA3 ecm first, then SECA2
#
# When "Ignore SECA2" is enabled, ignore all SECA2 ecm so a SECA3 card will not get SECA2 request which it cannot handle
#
# When "Ignore SECA3" is enabled, ignore all SECA3 ecm so a SECA2 card will not get SECA3 request which it cannot handle
#
#
# The following settings can be used
#
# SECA HANDLER: <value>
# <value> : 0 = disabled, 1 = prefer SECA3 over SECA2, 2 = prefer SECA2 over SECA3, 3 = Ignore SECA2, 4 = Ignore SECA3
#
default: 0
#
# Example try to use SECA3 ecm first, then SECA2
#SECA HANDLER: 1
#
# Example try to use SECA2 ecm first, then SECA3
#SECA HANDLER: 2
#
# Example to ignore all SECA2 ecm so a SECA3 card will not get SECA2 request which it cannot handle
#SECA HANDLER: 3
#
# Example to ignore all SECA3 ecm so a SECA2 card will not get SECA3 request which it cannot handle
#SECA HANDLER: 4