how to set this up: diseqc + splitter | |
Hello everyone..
My dish wiring looks like:
a single LNB -> dish with diseqc motor -> 4-way-splitter ---> receiver A and receiver B
So the splitter is after the diseqc.
The signal wire starts at LNB, goes thru the diseqc, then finish at the splitter. Then two wires go out from the splitter to the two receivers.
Receiver A is a FTA dumb thing.
Receiver B is a Dreambox 500.
I just got the Receiver B, and I am not sure if this cabling is correct. Should I get a dual-LNB for example, and remove the signal splitter, and wire Receiver B directly to the second port of the dual LNB? Or would this work as it is?
Many thanks,
-turgut |