Manhattan 6900 & STB editor

AndrewDunn · 11-07-2004

Connected up my Starlight 6900 with a null modem cable and I can upload the configuration from the receiver, but when I try to write back a configuration, I get: "Please, Try STB power OFF and ON"

Powering OFF and ON does not help - still get the same error.

ChrisW · 08-09-2004

If you're not already doing so:
- you must start with the PC connected to the receiver, but with the receiver switched off
- then start the transfer in Stb Editor
- when Stb editor says power on etc then switch on the power to the receiver - the data transfer should then start
- if it doesn't then switch off the power and then switch it on again
- when transfer has finished switch off the receiver

[I switch on and off by plugging in/unplugging the power lead at the back of the receiver]

It worked on mine

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Manhattan Starlight 6900/STB Editor Problem	inabsentia	DISH SETUP: Single sat, Multi-Sat & Motorised systems	3	12-10-2005 02:23 AM
Manhattan editor d/l problem	enmac	Receiver software, international Section	9	11-10-2005 11:46 AM
STB editor & Manhattan 6900-downloading Satcodx	AndrewDunn	Receiver software, international Section	3	20-09-2005 04:30 PM
Dragon CAM on Manhattan Starlight 6900	latin01	Cards & Programmers General	0	15-09-2005 09:00 PM
STB Editor For Manhattan Starlight	inabsentia	Receiver software, international Section	3	02-08-2005 10:45 AM

Manhattan 6900 & STB editor Information exchange on digital satellite systems other than Sky

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)