astra19.2 east

handyman 44

hi compleat newby hear trying to alinge dish for little old german ladie . she had digital system fitted by this chap the bolts came loose and it droped down a tadge. so i have some Q PLEASE. I LOOKED ON LYNGSAT SITE AND THERE SEEM TO BE HALF A DOZEN SATS 1C 1H 1G ECT WHICH ONES DO THE DIGITAL AND ANOLOG ARE ALL THE GERMAN CHANNELS ON ONE SAT. MY METER (WOLSEY) SEARCHES IN V AND H WHICH SETTING SHOULD I USE PLEASE HELP ME

rolfw

There are several satellites, but they are co-located, so find one, you've found them all. The Wolsey should have a valid transponder set in its memory, so check on both vertical and horizontal.

PS. The analogue channels are mostly on the lower band, there are digital channels on both high and low bands.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

handyman 44

thanks wolfw my meter has h and v but not high and low do i need some more equipment to set it up

rolfw

No, that will be fine.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

handyman 44

hi i set up the dish useing my wolsey meter and still picture was freezing and blocking up also high pitched beeping/squeking intermiting noise .so i gave up on the meter and ran an rf cable from the receiver to the the dish with a tv tuned to the signal strength screen built in to receiver. i then alinged the dish i had good signal strength 9 db the scale only went to 10 db and the quality was 70 percent this was the best readings i could get .but still some channels were blocking and freezing motsly channel 522 (das ereste) and up the lower channel number seemed ok .this problem hapened over night the make of the receiver is a triax dvb75 51 do you think there could be a problem with the receiver or have any one encounted any problems with this receiver .most greatfull rof any feedback

lasharratt

the most likely problem will be the dish alignment. It may be slightly out of place. If you can see the TV from where the dish is, tune in the channel which keeps freezing and *slightly* tweak the dish until the freezing stops. Make sure not to move the dish too much as you might need to re-align the dish again if you loose the satellite.

handyman 44

would the dish need to be level because when the dish first came loose itwas twisted slightly to the left as the bracket holds the dish vertical and upright so i used a spirit level .the lnb can be twisted clockwise as you look at the dish should this be level .i thoght i just got the strongest signal possible and the dish was set up but it do not seem to be the case

rolfw

What type of dish is this and what size? The LNB should be skewed a small amount for Astra 19.2 E, probably about 7 O'clock (assuming that you are in central UK.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

Channel Hopper

First, make sure the cable hasnt had water get into it, there should be insulating waterproof tape on the outside connection. Check both inner and outer connections, they should be tight, and both inner and outer conductors shoulc be corrosion free. Cut back and remake if they are not

While viewing one of the strong channels, put a wet towel over part of the dish until its starts blocking, then adjust the dish position of dish and LNB until the picure clears

Then remove towel

There is a very fine line between "hobby" and "mental illness"

handyman 44

the cable and conections look good the lnb is at 6 oclock i wont know untill tommorow the dish make and size but its only 2 years old and its a eliptical shape like mini dish but bigger .do profesional sat installers have these problems or is there some sort of super duper sat meter that they use .because i spent 300 pounds on a meter i thought it would eliminate the need to carry a tv onto the roof ps thanks for all the help keep it coming .