Moteck 2100 and 1.2 dishes

nilefish

Hi every one
I have Motcck 2100 motor working fine with my Triax TD110 , and I'm picking many satellites between 42E & 30W , bit the signal is very week on some of Viasat Denmark channels on Sirus -I have on official card and receiver- so I'm thinking to uprade to 1.2 dish -Giberitini 125 forexample-but I'm not sure if it's too heavey for my motor did any one tried this before? the manual says it can handle UP TO 1.2 m .
Any Help appreciated.
Thanks

__________________
DB 500 S, Strong 4622, Viasat Denmark, Triax TD110, Moteck 2100 Motor,infinty programmer, Cas Interface 2

CROSSBONES

I personally would not mount that size dish on the moteck.

But saying that the gib dish isn't that heavy, its just the wind loading you have to worrie about.

Do you have the dish in an open area?

Theres is a polar mount available for the gib dish`s. much better than disec. You would also need a vbox if you use a 36v motor on the mount.

rolfw

I wouldn't put one on a Moteck SG-2100, too heavy and too much windage.

The Gilbertini 1.25m is heavier than it looks, as it has a very sturdily built back mount and boom.

An acquaintance of mine has one on a Stab motor in a very sheltered location and even that struggles.

__________________

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below

nilefish

Thanks both CrossBones & rolfw for the quick replay..I have the dish in the balcony and there is open area in the fron ..then it's windy my dish is almost fly awayn so is there any other motor how can handle 1.20 dish, can I have more information's about that.

Thanks

__________________
DB 500 S, Strong 4622, Viasat Denmark, Triax TD110, Moteck 2100 Motor,infinty programmer, Cas Interface 2

rolfw

Your best bet would be something like the Jaeger 1224, there are a couple of recent threads about this motor, but you will also need a V-Box to interface with your DiseqC receiver.

__________________

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below

nilefish

Thanks alot, I will try to find some of the recent threads about this motor.

__________________
DB 500 S, Strong 4622, Viasat Denmark, Triax TD110, Moteck 2100 Motor,infinty programmer, Cas Interface 2

johnsattuk

Another possibility is to use a DisecQ jack on the polar mount.

__________________
Oldgeezer

rolfw

Saw one at a show some years back, but haven't seen one in use, anyone tried one?

__________________

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below

johnsattuk

I have a SuperJack 'DARL - 1208+' DiSEqC 1.2 actator. I have had a play with it and it works OK, just not got a setup that uses jacks.

__________________
Oldgeezer