LNB Short, how do i fix error ?

**cdtronix** · 01-11-2007

Disconnected the LNB cable into my echolink box last night to reconnect up another box to my dish, then i forgot to turn off the box before i reconnected it back up again, Im now getting the "LNB SHORT" message on the screen which i have never come across before.

Whats the solution to fixing this, where do i start ie Receiver, Cable, LNB ?

Just to add mysetup is a monblock LNB astra/hotbird

thanks in advance.

**johnwilliam1** · 01-11-2007

Originally Posted by cdtronix

Disconnected the LNB cable into my echolink box last night to reconnect up another box to my dish, then i forgot to turn off the box before i reconnected it back up again, Im now getting the "LNB SHORT" message on the screen which i have never come across before.

Whats the solution to fixing this, where do i start ie Receiver, Cable, LNB ?

Just to add mysetup is a monblock LNB astra/hotbird

thanks in advance.

i once had a similar problem it might not be the case but i ended up having to get a new power supply put in, mind you can always try putting another lnb on the end

**rolfw** · 01-11-2007

Check the connectors, particularly at the receiver end, that is probably the source of the short.

**cdtronix** · 01-11-2007

I'll get my meter out later and test the LNB and see if its that, i did read elsewhere that the box may need a factory reset, didnt want to do that yet cause i'll loose all my channels that ive spent hrs setting up the way i like.

I'll start with the LNB and go from there.....

**cdtronix** · 01-11-2007

Originally Posted by rolfw

Check the connectors, particularly at the receiver end, that is probably the source of the short.

Cheers will also check them as well.

What is an LNB short ? whats happening ?

**rolfw** · 01-11-2007

Most times a power off at the mains will reset the short protection in a receiver. Always check the parts you have changed first, the connector at the receiver end is the prime suspect.

**cdtronix** · 02-11-2007

It turned out to be one of my connecters was the problem. I used my sat meter and was able to locate which connecter it was within a few minutes and fix it.
Nice little exercise for me to do, im sure that will come in useful in the future ;-)
Thanks all.

**4dbennett** · 02-11-2007

Originally Posted by cdtronix

It turned out to be one of my connecters was the problem. I used my sat meter and was able to locate which connecter it was within a few minutes and fix it.
Nice little exercise for me to do, im sure that will come in useful in the future ;-)
Thanks all.

what exactly was wrong with your connector m8

deep joy

dave

**cdtronix** · 02-11-2007

Originally Posted by 4dbennett

what exactly was wrong with your connector m8

deep joy

dave

when i took it off, it looked like the outer (earth) thin wires were touching the main centre wire.

I cut it back and re done it and all was working fine.

saemoenl · 4 Weeks Ago

Hi Cdtronix,
I had that similar problem affecting my two clarke tech receivers....Please do help me and explain the way to handle the problem.
I will be glad to see that work for me.
Thanks in advance..or you can still reach me with my email address below...removed admin

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

LNB Short, how do i fix error ? Information exchange on LNBs, Single satellite, motorised and multi-satellite systems. DiSEqC switches, positioners, motors, actuators, dish-alignment etc.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)