Eurobird 9 | |
 |
| | Thread Tools | Display Modes |
| |
| |||||||
05-03-2008
| #1 | ||
| Information Exec  Join Date: 07-05-2007 Location: Midlands (UK) & Lanzarote (Canary Islands)
Posts: 1142
Thanks: 1
Thanked 140 Times in 136 Posts
My System: 43cm Dish, Sky Plus, FRACARRO PENTA 85, Invacom Twin, Moteck SG2100a H-H DiSEqC Motor, TF5000CI, TM-5200D, Rover Discovery ST-4, Rover SDM-1s, 57E to 58W |
Some info please Although I can pick up the channels I want from 9 East with the dish motor looking at 10 East, I have decided to add a new sat as it's not in my sat list menu under USALS. I have added a new satellite called E9 @ 9 East All I have done is the following: INSTALLATION> SAT/Tp EDIT> Named a satellite E9, then switched ON Diseqc 1.3 and punched in 9.0 East> Then GOTO> (dish moves) The dish now moves to 9 East position and scans the only one Tp I told it to, (11823 H) 27500 when I added the satellite to the list. Works fine, but..... When I then go back to a pre-programmed satellite from the list in USALS , lets say 5 East, the motor doesn't turn until I switch on the Diseqc 1.3 / USALS AGAIN , then it works fine?? It only does this with the satellites I have recently added being 58 West and 9 East as they were not in the sat lists. I have a Topfield 5000CI Rx Any ideas?  | ||
|  |
|
07-03-2008
| #2 | ||
| Information Exec Join Date: 07-05-2007 Location: Midlands (UK) & Lanzarote (Canary Islands)
Posts: 1142
Thanks: 1
Thanked 140 Times in 136 Posts
My System: 43cm Dish, Sky Plus, FRACARRO PENTA 85, Invacom Twin, Moteck SG2100a H-H DiSEqC Motor, TF5000CI, TM-5200D, Rover Discovery ST-4, Rover SDM-1s, 57E to 58W | Any thoughts guys and girls? | ||
|
| |
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
