diseqec1.0

mostafa shawky

hi every body
this is my first thread on this site and i want to have an answer for this qu ....how to use vbox as diseqec 1.0 postion using manual then set up 4 sats play i have mutech 8800 receiver and vbox ii positioner i can not find any sat ........................... how could i set up 4 sats plz any one can have answer for my question ?????????????????????????

rolfw

Have you aligned your motor and dish properly?

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

mostafa shawky

yes they are aligend true as i use now nile sat but i can not search for more satallites(i don't know how to search for satallites plz answer me

mostafa shawky

i find in the manual of the positioner this statment ....1. Drive the Actuator High/Low via the < and > buttons to the required position. Keep
pressing the Power button for 5 seconds, the Display will show “C_ _”.
2. Press the < MANUAL> buttons to scroll the position numbers on the display (1-99)
and to choose the sat. positions you want to store. (Only 96, 97, 98 and 99 will be
effective for DiSEqC1.0 receivers)
3. Press the “POWER” button within 3 seconds for confirmation; the LED will show
the number you chose...................the question here how could i Drive the Actuator to the required position,otherwise how to determine the position of the sat ..........................plz any one reply

rolfw

You set your receiver to DiSEqC 1.2 mode, select a satellite and drive the dish using the East/West button in the DiSEqC menu, monitoring the signal strength and quality readings. When you get good readings, scan a single transponder to check that it is the correct satellite, then save and do a full scan.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

mostafa shawky

my receiver is on system diseqec 1.0 and the nile sat installed on the receiver and i use it now but the problem is how to go to the required sat by positioner or by receiver known that i have mutech8800 receiver

satelliteman

You need DiSEqC 1.2 on the receiver for positioning. You can however drive the motor and store positions using the Vbox directly but a little more cumbersome to set up and operate.

satelliteman . ..... A Detailed DiSEqC Motor Installation Set Up Guide > HERE Quick Reference Guide also > HERE Satellites UK site Advertisers . An Installers Choice ...... Follow us on .

mostafa shawky

plz tell me the main and general steps for doing this .................thanks