strong 4375 problems installing for analogue

ronn · 01-02-2004

after repair of my strong 4375 i try to reinstall my favorites. I use fixed dish with two heads for Astra digital and Hotbird analogue resp. Digital astra inmediatly succesfull. Analogue Hotbird not succesfull. No channel does appear. What did I wrongly? Loop in loop out connected. antenna connected to lnb d.
Please advise.
ronn

**rolfw** · 01-02-2004

Did you set the DiseqC setting for Hotbird in the satellite/LNB menu?

ronn · 01-02-2004

Originally Posted by rolfw

Did you set the DiseqC setting for Hotbird in the satellite/LNB menu?

please give guidance. where i have to set the disq settinng?

**rolfw** · 02-02-2004

I'm making the assumtion that you have a DiseqC switch and only have a single cable coming into the receiver .

You have to go into the LNb/satellite setup menu Ronn, not sure about what the menus are called on the strong, but you need to enable DiseqC on the second LNB and call it 2 or B, then you should be able to see the second sat.

ronn · 02-02-2004

Originally Posted by rolfw

I'm making the assumtion that you have a DiseqC switch and only have a single cable coming into the receiver .

You have to go into the LNb/satellite setup menu Ronn, not sure about what the menus are called on the strong, but you need to enable DiseqC on the second LNB and call it A or B, then you should be able to see the second sat.

thanks you put my on the right track. I had to call them 1 and 2. problem sloved. thanks again. ronn

**rolfw** · 02-02-2004

Great stuff Ronn, good to see that you are back up and running.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Strong 4375 upgrade	refinechange	Receiver software, international Section	5	30-01-2008 02:07 PM
MR on Strong 4375 (& Hispasat)	Godzuki	DISH SETUP: Single sat, Multi-Sat & Motorised systems	5	04-05-2004 08:39 PM
Few people seek help for sex problems	net1	The Meeting Place	0	22-08-2003 08:11 PM
strong srt 4375 problems	jamie2001	Transponders & channels	17	12-11-2001 01:09 PM
Problems with Strong 4375 firmware 1.01 upgrade	Stargazer	Receiver software, international Section	4	07-02-2001 11:06 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

strong 4375 problems installing for analogue Information exchange on LNBs, Single satellite, motorised and multi-satellite systems. DiSEqC switches, positioners, motors, actuators, dish-alignment etc.