bit error rate help needed

slimthug

i cannot seem to get down my (ber) bit error rate it is always about 160000-5000 even though my (snr) is always about 91 and (agg) is about 41 i tried moving the antenna and it doesn't work the ber is still to high i would lik some help if possible.there are no trees in the way and no high wind.

rolfw

Is your picture breaking up?

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

billnot

As rolfw has suggested, if your picture is OK then stop worrying.

If your picture is breaking up, then it may be time to check your alignment and LNB. Since signals in general are at theiur weakest at this time of year, I change more LNBs between June and August than I do for the whole of the rest of the year.

slimthug

yes it is breaking up

billnot

Before blaming the Dreambox, check the rest of your installation. In Europe at least, this is the time of year when any shortcomings in dish alignment or LNB sensitivity make themselves felt.

slimthug

i replace the lnb cable and the same problem can it be the antenna

rolfw

Check the Skew/rotation of the LNB as well.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

slimthug

what is that?

slimthug

the box was showing good about a month ago and now it just breaking up with squares even tho the snr is 90. Sometimes it just stick and say switch service could not be found but i does just change the channel and that goes away.

slimthug

don't worry about me i'll find something to fix it so don't reply anymore

billnot

The skew is the angle that the LNB is fixed at relative to vertical. In other words, it doesn't usually point straight down, but needs to be twisted an an angle which will depend on where you are and which satellite you're pointed at. Sometimes it can be very critical (i.e. for pulling in Astra 2A and 2B north beam channels which have adjacent and very much stronger south beam transponders).

PJ02

According to those stats your signal level is only 41% which is a little low. You sure your all aligned correctly?

HTH

PJ