Disec motor!

CROSSBONES

Being a 36v motor fan, what is the best way to set up a disec motor on a 7025?

I have tried using usals, and assigning satellites with numbered positions, but having trouble storing the sats.

There`s plenty of signal when I measure using my meter, but when scanning the satellites using the dreambox tuner, the signal is very low and hence making it difficult to find sats The signal bars are jumping around all over the place!

Im using a Technomate disec motor.

If I use usals how do I store the sat positions?

Like I said i much prefer 36v and vbox set ups

rolfw

Moved this to the Dreambox section, as it is really specific to the Dreambox.

I found that the only image to work with USALS on my DM7000 was the new Gemini, but even that worked better with DiSEqC 1.2, like you I found it quite difficult to locate some of the sites and resorted to having my meter in line from the loopthrough.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

CROSSBONES

Yes good Idea, didnt think of putting the meter on the loop through

Nice one rolfw

Ive still got to find a way of storing the sats

pantnick

count me too on that...! and please let me know if you find anything...I `ll do the same of course

starman345

If using Usals you don't store sats, the direction and position is calculated each time using your latitude, longitude and the orbital location of the satellite you have selected.

compufunk

Im not sure about Enigma2 images, On my DM600 I can use a combination of USALS + stored positions. I used this for a week or two after a storm moved my kit out of alignment.

To do this, I sent the motor to the desired bird using USALS, then go to the motor setup page, use the menu to move the dish east or west till you get a the best signal you can. Then hit the button to store the position. (Green I think).

When you come back out of that menu, you may need to re-enable USALS. When you now select that sat, the motor will move to the stored position rather than the calculated one. (It does on the DM600 at least)

Hope this helps

compufunk

PS: I've found USALS to be bang on outside of when my kit has been blown about. I would prefer not to have to store positions if I can avoid it,

CROSSBONES

Thats the problem, when I set the settings to use usals, the dish wont move.

When I assign sat positions, only some times the motor moves