Anixe HD and Astra HD at 19.2E

icarusi · 03-12-2008

Can anyone here receiving these channels get the P or P+ to show these channels from standby. The only way I can get them to show correctly is to go via an SD channel. Still sometimes getting lockups requiring a hard start, if I use the channel up/down buttons or list selection rather than the numberpad. Ditto with HD channels on 28.2 shortly after switch-on.

howardbowell · 20-12-2008

Yes, have found exactly the same problem.

Have you edited the channel list via computer? I have and believe this to be the problem.

If you do a factory re set and use the standard settings every HD channel will work. Very strange!

icarusi · 21-12-2008

Originally Posted by howardbowell

Yes, have found exactly the same problem.

Have you edited the channel list via computer? I have and believe this to be the problem.

No, just the standard scan from the P+.

If you do a factory re set and use the standard settings every HD channel will work. Very strange!

I wonder if the preset pids or symbol rates are a bit off, or something? I'll have a double check with Lyngsat. Radio on 28.2 is similarly iffy from startup. I need to go to TV and back or from standby to get a signal.

OTOH my LNB may be slightly off frequency which wouldn't help matters.

howardbowell · 23-12-2008

Use channel editor version 1.01, and problem is solved. Try it!

Also upgrade pox to the latest firmware, available from the fortec website.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Anixe HD and Astra HD at 19.2E High Definition FortecStar HD satellite TV receiver help and support forum.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)