Unaohm & diSEqc switching?

malsat

Is anyone using Unaohm 314 spectrum analyser?
I am wanting to know how to change diseqc switching when setting up a monoblock lnb,when ligned up on Hotbird so i can peak the Astra signal.
thanks

rolfw

Unfortunately my EP313 doesn't have DiseqC switching, but you might perhaps PM iceman, as he uses a 314, I'm sure he won't mind.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

malsat

thanks rolf
I see you have a Annie,whats it like?
can you pre store digital channels from any sat and then use them to peak the signal on a later install?
thanks

iceman

@malsat
Unfortunately i have never used the DISEqC functions on the Unaohm EP314 so i will not be able to offer any advice...
I have the manual for the meter if that is any help to you...could send you the relevant section if you wish..

iceman

rolfw

Yes, I use the Annie mostly for terrestrial though, as I find the Satlook NIT better for satellite work, you can as you say save both channels and traces for comparison.

Rolf If you enjoy our site, you can help support it by wearing our unique branded merchandise, you can do this by clicking on my baseball cap, making a direct donation with Paypal by clicking on the Donation button below, or using our site supporting advertisers, to do this, click on the central image below. Follow us on Twitter, click on the twitter image.

malsat

Thanks guys,
yes can you send me the relevant section please Iceman.
thanks again

iceman

DISEqC Module on EP314
The DISEqC module adds to the EP314 peripheral drive in conformity with the DISEqC 1.1 standard.The trasmission of repeated commands is not allowed.

How to enable/disable DISEqC 22kHz note
1.Press the key DSQ/22k
2.Use the multifunction keys UP or DOWN to position the cursor in correspondence with the 22kHz reading.
3.Press SSQ/22k to alternatively enable/disable the tone.The presence of the signal is indicated on the OSD dsiplay.
4.Once the function has been performed,the EP314 returns to normal operating mode.

Transmission of a DISEqC command
1.Press the key DSQ/22k.
2.Use the multifunction keys UP or DOWN to position the cursor in correspondence with the DISEqC reading;this is followed by the name of the last cmmand transmitted.
3.Press DSQ/22k to transmit the same command.
4.Once the function has been performed the EP314 returns to normal operating mode.

At the previous point 3,to transmit a command different from the one proposed,proceed as as follows:
1.Press the multifunction key SELECT
2.Select the command to be transmitted by means of the multifunction keys UP and DOWN.
3.Press DSQ/22k or BACK to return to menu,which will have been up-dated to include the new command.
4.Press DSQ/22k to transmit it.

Hope this helps