99% load but cam still works

**glesgaguysat** · 15-09-2006

Hi just loaded the latest 3.39-1509 (latest D+) the cam loads to 99% and reports "loading succcess" seems to work OK but is this normal (99%)
Worried because it seems a file was uploaded with a virus

**Mickha** · 15-09-2006

Hi glesgaguysat,
usually I don't bother refreshing to see how far the Cam has loaded, I just wait until the Cam is loaded and the remove card message is displayed.
If the Cam is working it should be fully loaded, go through the menus and see if the Cam states Predator 349, also check if all the items, in the menu, are there, especially in debug.
If the bootloader was damaged your receiver wouldn't be recognising the Cam, just use it and see if it re-loads next week with the updated file.
Best wishes
Mickha

***remlap*** · 15-09-2006

UM D+ Is open?

**Mickha** · 16-09-2006

D+ isn't open, as far as I'm aware, on the Dragon and the latest Predator is 3.49 1509.
Before loading any predator file into your Dragon Cam you should always do a checksum of firmware test with the DCP or Dragoncrypt utilities.
There are some malicious people who seem to think it is clever to spread fake files, some of which can damage cams.

D+ and Cabo are open on the new T-Rex supermodule 4.5 but they use predasaurus files which don't work in earlier versions of the Dragon/T-Rex cams.