88' ST1 Ku Conax basiccard Jammed- Help!!!!!

K

kschar28

Member
Messages
5
Likes
0
#1
I have the origianl conax card for St1 ku Conax card and can view with my decoder (Magix firmware ver 2.3.9) but after 20-30 minutes, it will stop and screen turn blank black and i had to switch off and on again the decoder to continue, but same happen again . Is it due to the Firmware version( too old ) or the CAM ?? (The cam is meant for Ir2 and V2 as inform by the seller). Can Any expert to offer help, thanks in advance.;)
 
W

weixing

Member
Messages
1
Likes
0
#2
kschar28 said:
I have the origianl conax card for St1 ku Conax card and can view with my decoder (Magix firmware ver 2.3.9) but after 20-30 minutes, it will stop and screen turn blank black and i had to switch off and on again the decoder to continue, but same happen again . Is it due to the Firmware version( too old ) or the CAM ?? (The cam is meant for Ir2 and V2 as inform by the seller). Can Any expert to offer help, thanks in advance.;)
Xsat 410 series with firmware re-programmed works very well with the conax card for ST1 conax. No problem at all.
 
Top