Adjustable wall mounts?

DuncanEK3

Arcade Bandit
Messages
20
Likes
0
#1
Hi,

I'm planning on installing a motorised 90cm dish on the north wall of our house (looking over the roof), however I know the wall isn't dead on verticle. Are there any wall mounts/brackets which can compensate for this?

Mounting on the ground isn't possible due to trees surrounding the garden.

Regards,

Duncan :)
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,698
Likes
1,286
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Most T&K brackets have a small amount of adjustment and there is nothing to stop you extending this with a drill and file.
 

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,189
Likes
5,621
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#4
Its a common misconception in the industry where people advise that the post must absolutely be vertical

With a polarmount and the three adjustments, any non vertical post can be compensated for up to about 5 degrees in any direction, but it can take time, even if you are a good installer
 
Top