orzem
Regular Member
- Joined
- Mar 7, 2005
- Messages
- 28
- Reaction score
- 0
- Points
- 0
- Age
- 52
- My Satellite Setup
-
DB 5620S
Linux Debian PC
Hi,
I recently asked for info about emu manual installation and got very
useful answers.
I studied a bit the subject and my new dreambox, and now here I come,
quite desperate admittedly, because my dreambox acts weird and I'm worried.
I have set up my Debian PC with address 192.168.0.1, ethernet card eth0.
Plugged in a 5 m. crossover cable.
Configured the dreambox as 192.168.0.3 (192.168.0.2 is my notebook)
and started a telnet session. Everything fine.
Logged out and started an ftp session to pack my dreambox with newcamd emu
as per info received (emu on original image).
Here comes the problem: communications get stuck after only a few packets.
Actually the whole dreambox gets stuck, the only option is to turn it off with the power switch on its back.
Come to look a little closer at telnet sessions, they get stuck too after a few commands.
Ping works fine with 64 byte packets, 100 bytes packets, 200 bytes packets.
Ping flood gets stuck.
This happens also from my WindozeXP notebook and also with DreamupLAN.
I believe this is a software or configuration problem, but really can't figure it out.
The dreambox DREAM/INFO panel says DM5600, software version beta 1.0.2
I'd like to upgrade to rel106.img, and since LAN is not working properly, I'd like to
have info on how to setup minicom for a serial connection with my Debian PC, the only one with a serial port on it.
I tried to connect the dreambox via serial null modem cable with a WondozeXP PC, started DreamUP, com port 1, connect and nothing happens...
I'm in bad need of something to hope for...
Thanks
orzem
I recently asked for info about emu manual installation and got very
useful answers.
I studied a bit the subject and my new dreambox, and now here I come,
quite desperate admittedly, because my dreambox acts weird and I'm worried.
I have set up my Debian PC with address 192.168.0.1, ethernet card eth0.
Plugged in a 5 m. crossover cable.
Configured the dreambox as 192.168.0.3 (192.168.0.2 is my notebook)
and started a telnet session. Everything fine.
Logged out and started an ftp session to pack my dreambox with newcamd emu
as per info received (emu on original image).
Here comes the problem: communications get stuck after only a few packets.
Actually the whole dreambox gets stuck, the only option is to turn it off with the power switch on its back.
Come to look a little closer at telnet sessions, they get stuck too after a few commands.
Ping works fine with 64 byte packets, 100 bytes packets, 200 bytes packets.
Ping flood gets stuck.
This happens also from my WindozeXP notebook and also with DreamupLAN.
I believe this is a software or configuration problem, but really can't figure it out.
The dreambox DREAM/INFO panel says DM5600, software version beta 1.0.2
I'd like to upgrade to rel106.img, and since LAN is not working properly, I'd like to
have info on how to setup minicom for a serial connection with my Debian PC, the only one with a serial port on it.
I tried to connect the dreambox via serial null modem cable with a WondozeXP PC, started DreamUP, com port 1, connect and nothing happens...
I'm in bad need of something to hope for...
Thanks
orzem