Conax - with Echostar 3000Ip Viacess

[veton]

Hi guys , can somebody solve my problem ?

I have Digitalb -card with Conax module , and I am using Echostar 3000Ip Viacess receiver ,but the problem that I have is that when i watch this Digitalb chanels every 20 - 30 seconds chanels are freezing for 2-3 seconds.

Thnx in advance.

 

[Channel Hopper]

Some receivers do have trouble with the high symbol rate of the channels on this package, Manhattan springs to mind, but I would hedge my bets on incompatibility of the Conax Cam with the receiver.
Have you got the latest Echostar Firmware - (series 110) installed ?

Have you tried another receiver ?

 

[veton]

Yes I have tried ,in another receivers is working fine,but in this Echostar 3000Ip Viacess I have this problem ,and I have the latest software for this receiver ( series 1000 ),as i know this series 110 is only for Echostar 3000 but not for 3000 Ip Viacess receivers.

Thnx.

 

[Burnham Beech]

I'm into wild guesses here.

Firstly, 1000 is the latest for Echostar 3000Ip Viacess and is ok for the 32000 SR used by DigiAlb - as I'm sure you have checked already the DigiAlb FTA channel is ok.

Working for 20 - 30 seconds then freezing for 2-3 seconds sounds like a Control Word problem. To eliminate the obvious - what version conax cam are you using - have you removed any card in the embedded via slot and any cam in the other CI slot.

 

[veton]

I have tried also with Dragon and Matrix card , but same problem ....

 

[Burnham Beech]

Nope, no idea. You seemed to have eliminated the obvious answers with your extra tests.

All I can add is that the Echostar 3000ipva worked fine with the unofficial conax cards that were available last winter. But I have never tried a DigiAlb card.

 

[veton]

Thnx very much Burnham Beech

 

[jimbo]

I've had no problems with a digitalb card in a Manhattan ST550. I used a Technisat Technicam (Conax) with is cheaper than the Eurocam version 4.01 or the 4.0e modified.