joshuatronic
Regular Member
- Joined
- Mar 9, 2005
- Messages
- 68
- Reaction score
- 0
- Points
- 0
- Age
- 59
- My Satellite Setup
- 98
hello everyone. there is a DIGITAL 1200 CI receiver for repair. when i turn it on it says Err.0. i reprogrammed the receiver with its firmware via PC link 2.5. the procedure goes up to 100% and says wait till it says GOOD on receivers front display but instead it gives me Err.4. i turn off and on receiver and it says Err.0 again. is it possible flash is damaged? or it just has to be unsoldered and programmed with bin using a flash programmer?? plz give any ideas guys. thanx