B
bibi bear
Guest
Can DiSEqC 1.2 motors get stuck on a single position from zapping too fast?
Hep me Lord! Hep me Lord! Please Lord Hep me!
'cause I got hard-core problems over here
Can/Does your very common (seen 'em everywhere) DiSEqC 1.2 motor get stuck on a single position?
I've haven't yet gone up to the roof but I seem to have lost control over my motor - I seem to be stuck on a useless position, hence no signal.
I was zapping (and changing positions perhaps a bit too rapidly) and now I'm stuck
SO IF this is the situation :
IS THE SOLUTION just to nudge it along ??
[ex.: as someone at the receiver calls upon the centering command]
bibi
Hep me Lord! Hep me Lord! Please Lord Hep me!
'cause I got hard-core problems over here
Can/Does your very common (seen 'em everywhere) DiSEqC 1.2 motor get stuck on a single position?
I've haven't yet gone up to the roof but I seem to have lost control over my motor - I seem to be stuck on a useless position, hence no signal.
I was zapping (and changing positions perhaps a bit too rapidly) and now I'm stuck
SO IF this is the situation :
IS THE SOLUTION just to nudge it along ??
[ex.: as someone at the receiver calls upon the centering command]
bibi