Dear all,
This is my first post as I have inherited a motorised dish system with an echostar 3000IP silver line. It came fully connected but I have been reliably informed that they have not used it for a year or so. I have read all the manuals and tried to set it the reciever but with no luck -
I manage to get the main menu screens and on it there are loads of satellites set up already and there are loads of channels in each satellite but each time i look at the channels it always shows the signal and quality bar at no more than 15% and the 'information' notice saying no signal.
Is there something else i need to do or is it best to reset the factory defaults and then start again as it has been a couple of years since this was given a run out.
This is my first post as I have inherited a motorised dish system with an echostar 3000IP silver line. It came fully connected but I have been reliably informed that they have not used it for a year or so. I have read all the manuals and tried to set it the reciever but with no luck -
I manage to get the main menu screens and on it there are loads of satellites set up already and there are loads of channels in each satellite but each time i look at the channels it always shows the signal and quality bar at no more than 15% and the 'information' notice saying no signal.
Is there something else i need to do or is it best to reset the factory defaults and then start again as it has been a couple of years since this was given a run out.