RustySpoons
Sleepy Hollow
- Joined
- Jan 31, 2018
- Messages
- 2,345
- Reaction score
- 1,278
- Points
- 113
- Age
- 42
- My Satellite Setup
-
50E - 30W
2x CM 1.2m Polar Mount/Jack
65E- 65W
Gibertini 1m OP100 - STAB HH100 - Inverto Black Ultra 0.2 Twin
Mutant HD51
Edision Primo IP S2
Dreambox DM800HD
Venton Unibox HD2
Sony Bravia 55" 4K
- My Location
- South Wales
If for whatever reason you manged to brick your box or want to do a clean re-install/upgrade (Normal update does not do a clean install and factory reset does not clear everything)
Warning! this will remove any settings you have changed! Including all channels/transponders you have saved.
Do the following steps:
1: Download the firmware you wish to install, unzip it and put it on the root directory of a USB stick (Ideally make sure its formatted first)
2: Put the USB stick in to one of the USB ports on the receiver.
2: Unplug power lead from the receiver.
3: Ensure the HDMI lead is connected and your TV is on and the correct input is selected.
4: Plug the power cable in, as soon as you see the word "boot" displayed on the front of the receiver press the power button until this changes to "upg".
5: You will see the boot logo displayed, then wait patiently and a "Firmware Update" menu is displayed.
From here press the red key on the remote, it will then pop up with the firmware file on the USB drive, select this file and press "OK" on the remote, it will then ask "Do you want to update firmware" select yes and press "OK"
Your receivers firmware will update and it will reboot.
Warning! this will remove any settings you have changed! Including all channels/transponders you have saved.
Do the following steps:
1: Download the firmware you wish to install, unzip it and put it on the root directory of a USB stick (Ideally make sure its formatted first)
2: Put the USB stick in to one of the USB ports on the receiver.
2: Unplug power lead from the receiver.
3: Ensure the HDMI lead is connected and your TV is on and the correct input is selected.
4: Plug the power cable in, as soon as you see the word "boot" displayed on the front of the receiver press the power button until this changes to "upg".
5: You will see the boot logo displayed, then wait patiently and a "Firmware Update" menu is displayed.
From here press the red key on the remote, it will then pop up with the firmware file on the USB drive, select this file and press "OK" on the remote, it will then ask "Do you want to update firmware" select yes and press "OK"
Your receivers firmware will update and it will reboot.