Fortecstar FSCI-5100 Plus Flash Error (Not Booting)

Messages
4
Likes
0
My Satellite Setup
Star-Track NC-708
My Location
Islamabad, Pakistan
#1
Dear Sir,
I have Fortecstar 5100 Plus. Yesterday, I tried
to update my receiver using Firmware - v.2.64 PAL (
April 25, 2005) using "Forecstar STB Updater v3.21".
After the downloading process had been completed, I
waited a few seconds and then turned my receiver off.
After that the receiver didn't boot and showed -20- on
the L.C.D. of the receiver and nothing was shown on
the screen.
My orignal "system information" was:
Al7Bar CI
Al7Bar - 2.18
09.02.2003
Please and again please help me in this matter,
I shall be very thankful to you for that.
from
Zaeem
 

Llew

cerca trova...
Staff member
Messages
14,407
Likes
3,367
My Satellite Setup
Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
My Location
The Flatlands of East Anglia
#2
Hi Zaeem.

Looking at your system info, you may have a very early Boot file. If it's 04 or earlier, you need to upgrade your software.

Go to _www.al7bar-soft1.com to download a repair file.

Llew
 
Messages
4
Likes
0
My Satellite Setup
Star-Track NC-708
My Location
Islamabad, Pakistan
#3
Thank You, Llew! My receiver is now working!
 
Top