Fortecstar FSCI-5100 Plus Flash Error (Not Booting)

[Zaeem]

Dear Sir,
I have Fortecstar 5100 Plus. Yesterday, I tried
to update my receiver using Firmware - v.2.64 PAL (
April 25, 2005) using "Forecstar STB Updater v3.21".
After the downloading process had been completed, I
waited a few seconds and then turned my receiver off.
After that the receiver didn't boot and showed -20- on
the L.C.D. of the receiver and nothing was shown on
the screen.
My orignal "system information" was:
Al7Bar CI
Al7Bar - 2.18
09.02.2003
Please and again please help me in this matter,
I shall be very thankful to you for that.
from
Zaeem

 

[Llew]

Hi Zaeem.

Looking at your system info, you may have a very early Boot file. If it's 04 or earlier, you need to upgrade your software.

Go to _www.al7bar-soft1.com to download a repair file.

Llew

 

[Zaeem]

Thank You, Llew! My receiver is now working!