Grundig EPG & Operating Sys. Update

[rato]

My Grundig GDS2000 has just been updated to EPG version 3.4.4b and the Operating System to 1.2S4FE. It did a reset and went to default transponder 11.778GHz. Did a new installation and selected the default transp. to 12129Ghz. Confirmed new installation. Now shows on channel list the new HD channels. Funny thing is that the Signal Test does not show nothing on SQ nor on the Lock Indicator showing OK. Network ID is 0000 and sometimes on the Transport Stream it's 0000 or the channel I'm watching. But everything else is functioning properly. On the new installation, the SS & SQ works + Lock Indicator goes to OK and shows the Transport Stream for 12129GHz. It is afterwards when you are normally watching a channel(say BBC for example), that when I go to the Service menu to check for SS & SQ does this happen.
Does anyone have the same problem, or is there a way around to "cure" this glitch?

 

[BadWithComputer]

This does occasionally happen if you are not on the default transponder. or the secondary one. (12051v27500) Try that.

 

[rato]

Well, it is now, thanks to my new dish + LNB and it now shows on the Signal Test just for the default transponders' signal on every channel. Has a background music on the sky menu which it didn't have when I was with the other default transponder from the South Beam. Thanks anyways Alex.

 

[Zorba]

Just cheat like I do,Type 12.205v. Over here thats the strongest and it always impresses the customers.