humax and matrix reloaded initializing

stevo

Regular Member
Messages
203
Likes
0
My Satellite Setup
dreamboxhd 800 pvr
2 x dreambox 500s
globalstar-m6 free to air
1 metre dish
80cm dish
60 cm dish
all via diqsec switch.
My Location
england
#1
ive read the manuel for matrix reloaded and have humax 5300,it says you have to initialize on another reciver,ive not got another recever how can i get around this.thanks stevo
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,698
Likes
1,286
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Some people have reported successful initialisation after repeated attempts in the Humax, but other than that, I'm not sure if there is an alternative.
 

benny

Regular Member
Messages
63
Likes
0
#3
Hi,
If you use a laptop to update your MR, then leave the MR in the laptop for about 5 mins, this will work fine.When you put it back in the humax have it on a FTA channel. You may not even need to update using a laptop, it may work if you just put it in the socket.The drivers will have to be installed though.
I think you can also get a Cas interface,but i don't know much about that.

Good Luck

benny
 
Top