Irdeto2 PCMCIA driver

Messages
2
Likes
0
My Satellite Setup
Humax
My Location
Egypt
#1
Kindly I need a win xp driver for Ideto2 PCMCIA p/n:904063 in order to install the Cam on laptop and upgrade its software.
 

Topper

Amo Amas Amant Admin
Staff member
Messages
21,550
Likes
3,244
My Satellite Setup
IDD CI24 ECONO MM Penta 1.20 Galaxy II
1.2Mtr Polar MTG yes it has been on the arc for 25 years and is now fixed on 13 East using two pairs of rusty molegrips. Unlike me they never groan but always perform.
My Location
Blackburn, Lancashire
#2
Welcome to the forum abdel_rahman

Have a look at the the files here I am sure you will find what you need
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#3
Messages
2
Likes
0
My Satellite Setup
Humax
My Location
Egypt
#4
1st I tried the files attached and the files in the web link, but still windows can not define the CAM.
The problem is I made upgrade CAM from the reciever (Humax CI-5100) after this the reciever cannot see the cam on any of its common interface.
So I thought that I might do this from the computer.

Please Advice.

Thanks to you all
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#5
Please follow the link I gave you, as far as the information there is concerned, you cannot upgrade that CAM, so you have probably broken it and it probably needs the chip removing for re-flashing.

You could try it in another receiver to see if it recognises the CAM.
 
Top