Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite Tv Encryption Decryption
Cards, Programmers and Cams
Cams and decoders General
Last hope: Schematic diagram of Freecam?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Haha" data-source="post: 7473"><p>Hi all,</p><p></p><p>after reflashing my Freecam (900264) with a fake 2-018 version I found that it was not recognized any more by the receiver. I spent really a lot of time with building the Ezo flash programmer (thanks Ezo! great work!) and after carefully removing the AMD flash memory and wasting many hours of sleep I managed to successfully program the flash memory. Unfortunately, when I put the chip back to its position, I found that the CAM is still not working. I have verified that the (tiny) pins do not short-circuit anywhere and they are correctly connected to the corresponding pins of the KM68100 memory chip (which uses the same pins for address and data bus). Since I am really very close to just dropping all this hard work, all I can think of is to find the schematics of the module and try to see whether every pin has been connected properly. I would greatly appreciate any help on this.</p><p></p><p>Desperately,</p><p>thanks in advance for any help.</p></blockquote><p></p>
[QUOTE="Haha, post: 7473"] Hi all, after reflashing my Freecam (900264) with a fake 2-018 version I found that it was not recognized any more by the receiver. I spent really a lot of time with building the Ezo flash programmer (thanks Ezo! great work!) and after carefully removing the AMD flash memory and wasting many hours of sleep I managed to successfully program the flash memory. Unfortunately, when I put the chip back to its position, I found that the CAM is still not working. I have verified that the (tiny) pins do not short-circuit anywhere and they are correctly connected to the corresponding pins of the KM68100 memory chip (which uses the same pins for address and data bus). Since I am really very close to just dropping all this hard work, all I can think of is to find the schematics of the module and try to see whether every pin has been connected properly. I would greatly appreciate any help on this. Desperately, thanks in advance for any help. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite Tv Encryption Decryption
Cards, Programmers and Cams
Cams and decoders General
Last hope: Schematic diagram of Freecam?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top