LNB/Echostar problems

R

RENF4D

Guest
I have a mono block lnb that switches between Hotbird and Astra. Since I did the OTA download for my 3000ip and then restored to the 900 version, I cannot get all the channels. It just says 'No Channel'.

I have the setting for the universal but don't get all the channels. I also use Disecq to switch between satellites.

Are there specific settings to use or do I need to change the lnb or receiver.

Many thanks :(
 

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
You need to setup the diseqC commands in the satellites/LNB menu to either A, or B, depending on which is which.

If you are pointing at Hotbird and Astra 1, try A for Hotbird and B for Astra, then if that doesn't produce results, try the other way around. :)
 
R

RENF4D

Guest
Tried, but I only get about 20-50 channels on Astra & Hotbird. Nothing over frequency 11900.

Is there a setting for the lnb, or receiver, or at worst do i change the lnb.

Thanks :confused
 
Top