Looking for a H-bend Waveguide

Likvid

ASBO Club Member - Persona non grata
Messages
1,752
Likes
5
My Location
Stockholm, Sweden
#1
Anyone have that at home laying around?

I need one quickly to my OMT.

It is the H-bend i need, not E-bend which is Easy.
 

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,474
Likes
5,701
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#2
Probably, though you should send me the dimensions required before and after the bend .

I take it this is for standard Ku band.
 

Likvid

ASBO Club Member - Persona non grata
Messages
1,752
Likes
5
My Location
Stockholm, Sweden
#3
3.3cm before and after, WR-75 flanges, choke/cover.
 

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,474
Likes
5,701
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#4
Likvid said:
3.3cm before and after, WR-75 flanges, choke/cover.

The ones I have here are 34 x 44mm, both ends have flat surfaces so you will need both LNB and feed to have o-ring recesses

Piccy attached
 

Attachments

Likvid

ASBO Club Member - Persona non grata
Messages
1,752
Likes
5
My Location
Stockholm, Sweden
#5
Ok, thanks but i really need the other flange to be able to fit a O-ring as my OMT doesn't have it.

Do you have any larger bends or smaller with O-ring in the other end?
 

Likvid

ASBO Club Member - Persona non grata
Messages
1,752
Likes
5
My Location
Stockholm, Sweden
#6
Channel Hopper:

Do you know if there is any performance difference between the Mitered casted bends and the Formed bends?
 
Top