HI all, I'm using an Echostar AD3000IP (V) with a 1.1m motorised dish. Had a problem recently with the motor and the installer put in a replacement so all seemed good again. That was until I went to the French FTA channels TF1 etc on 5 West which are in analogue. I get a 'no signal' message - these used to be fine. Any ideas on what I can check? Thought I'd have a go at troubleshooting (and learning in the process) before calling back the installer. Generally the I think the system is OK, can get channels on HotBird/Sirius but not any on Hipasat as far as I can tell.
Thanks for any advice.
Adam
Thanks for any advice.
Adam