M2 card

Messages
1
Likes
0
#1
Hi

I'm trying to program a M2 card with a MP3.5 programmer (firmware 1.10). The programmer is set to Phoenix 3.58MHz using Multiprog. I get a correct ATR response but then: Error - SW:

Has somebody any experience from M2 used with MP3.5?

Cheers,
Tom
 
Messages
5
Likes
0
#2
Ive got the same problem m8 but with a dynamite programmer. Please let me know if you find out anything. I will do likewise. Also if anyone can help it would be very much appreciated.
Thanx
 

Burnham Beech

Specialist Contributor
Messages
1,013
Likes
39
#3
Using a later Elvis with firmware 1.5 works fine.

There are a lot of posts on the StopStop board about this - you should get help there.
 
Top