MAGIC LOADER BOARD and MATRIX REVOLUTION CAM

jmgirard2001

Member
Joined
May 6, 2004
Messages
2
Reaction score
0
Points
0
Age
67
My Location
FRANCE
Does some one know if MAGIC MODULE LOADER board work for upgrading firmware of MATRIX revolution CAM.
I have tried with multicam Loader v3.5 and also with UCAS loader.
But laoder sofware don't reach the CAM.
My cable is good ant the loader board too because it work with my magic module !
Best regards
Jean
 

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
No it doesn't work, you need either a PCMCIA slot, funcards or a CAS Interface.
 

jmgirard2001

Member
Joined
May 6, 2004
Messages
2
Reaction score
0
Points
0
Age
67
My Location
FRANCE
rolfw said:
No it doesn't work, you need either a PCMCIA slot, funcards or a CAS Interface.

Many thanks for your answer !
I have Funcard7 (prussian 5) and all files to load the funcard (dynamite programmer) but loading de MRv in my SAMSUNG DSR 9500 seem to be correct but not !

Firmware indicated in CI menu is always 1.7.12.2.11.
even if i load the MRv with MRv221, 223, 224 prepared with splitter to have hex file.
I use flash for fun 7.
The CI menu indicate :
UCAS V3.1
Smartcard
Ci Ressources
Firmware
Download

Best regard JEan
 
Top