matrix problem

Messages
3
Likes
0
#1
i just bought a matrix reloaded cam , i have a samsung 9500
but the cam is not initzialed
and i have tried too turn that reciver on and off O-Ha but no success
what too do.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,697
Likes
1,285
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Have you tried changing slots? Also pulling the CAM out and replacing?

Some people have more luck by firing up the receiver when on a non-encrypted channel.

Also where did you get it from, some are delivered without software.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,697
Likes
1,285
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#4
You need a CAS interface or laptop, won't be able to do it with the funcards if your receiver doesn't recognize it.
 

Razor

Regular Member
Messages
1,319
Likes
0
My Location
Ireland
#5
Or send it to the DEN and have the latest files loaded....£15 + p&p.

If you do not have a CAS this is the best option.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,697
Likes
1,285
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#6
Don't think they are doing that any more Razor, too many people sending in fried CAMs and then expecting a replacement when it doesn't load.
 
Top