goldkat said:Hi guys,
This is first post in this forum
I want to buy a matrix cam but in doubt between a matrix reloaded or reborn. I have been reading in this forum that you can't program the reborn straight from a laptop, is that rite? I don't want to buy a cas loader (too expensive), so if reborn cams can't be updated by a laptop, I will just by a reloaded, as mrb300 seems to work on it as well. Btw, on gxmax.com on the matrix reborn section were you can find the mrb300 files, you can also get the pcmcia ucas loader for the matrix. Does this mean that it is possible to program the reborn with a laptop?
Thanx very much in advanced!
GoldKat
goldkat said:oh btw forgot to say. I'm spanish and will want to program the mrb300 to watch D+. Can I flash the ucas version 3.2 with my laptop as well? I wouldn't want to get a cas loader.
Thanks again
GoldKat
claasi said:PM seems to be deactivated for all folks. Used to work some time ago.
claasi said:IF you programm your REBORN with UCAS 3.2 and then mrb 3.00 you will have to stick to it becuase you can not go back to ZCAS MR T Soft.
gauch21 said:i have a reborn with zcas. can anyone target me to the website where i can find driver and loader utility to update mrt software on my cam through laptop.
goldkat said:So if i flash the reborn with UCAS 3.2, in order to go back to ZCAS I would need a CAS correct? Or is not possible yet to do this?
Oh btw, do I need a boxkey to watch D+ with mrb300? I've heard that the boxkey for the matrix is always the same, so the files should come with the correct boxkey, rite?
Thanks a lot mate!
GoldKat
gauch21 said:hi i have loaded my reborn with 'zcastoucas.upd' from speedy's website. now when i am loading it with mrt or mrv softwares it is showing 'device error: reinsert your cam'. please advise what shall i do?
goldkat said:Hi m8,
You only need to change from zcas to ucas3.2 when loading mrb300. MRV files work with ucas3.1 and MRT files work with zcas. Therefore the only way around your problem is to load the mrb300, if you use the laptop method. Alternatively, you can use a cas programmer, to load up any other files you want in it.
I'm guessing (not sure if it is write, some correct me if wrong please), you can use your laptop to go back to ucas3.1, and then install the mrv files. ucas3.1.upd is available, but zcas.upd isn't, so there isn't still a way back to zcas using a laptop.
Hope this helps
GoldKat
goldkat said:Hi classi,
I'm back hehe. Just got one more question. Is there any program to edit the mrb300 file? MRCrypt won't allow me to open the file in order to change the keys or to see the list of providers. Which program can i use?
cheers mate
GoldKat