• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

mediacom910i displaying "BOOT" perm. after upload

dugizul

Regular Member
Messages
52
Likes
0
#1
Hello guys,

Yesterday I uploaded my mediacom910i with software from http://www.mediacom.net.ms/ Updated:21/05/05.I used crossed RS232 cable.I did everything as required,upto when the upgrade was complete and the receiver displayed "GOOD" on the front panel,thereafter I switched off at the back.On switching on again it displayed "BOOT" permanently.Pls anyone assist with ideas.

THXS,

[email protected]