MoTECK SG2100A

Thor25rtn

Member
Joined
Jan 28, 2006
Messages
53
Reaction score
0
Points
0
Age
57
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
Hi Guys,
I hope someone can help.
Have had the motor for 6 months no problems.
Today it will not move via the remote with the reciever, but have green light and will move manually.
Could it be a motor or reciever fault?
Have checked all connections to motor and reciever all seem.
Any help or tips would be well recieved.
Cheers!:(
 
J

Jeff_19341

Guest
Motors sometimes forget where they are. Get your receiver to "Go to Ref" this should clear that type of problem.
 

Thor25rtn

Member
Joined
Jan 28, 2006
Messages
53
Reaction score
0
Points
0
Age
57
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
Hi Geoff,
Will try this later.
Thanks,
 

wolfav

Regular Member
Joined
Dec 18, 2004
Messages
470
Reaction score
0
Points
0
Age
53
My Satellite Setup
two sky+amstrad boxes
technomate5500ci+ with 80cm motarised dish irderto cam mr mrev +dragoncam blue tit numerous fun cards infinity pheonix compaq and dell on wirelessrouter
My Location
no mans land
i had the same problem one of my cable covers was letting in a bit of water in bad weather a bit of tape sorted it out no problem
 

Thor25rtn

Member
Joined
Jan 28, 2006
Messages
53
Reaction score
0
Points
0
Age
57
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
Have just used remote control to move to Astra 28.2,. so at least will move with this.,
Just not when another channel on another satellite is selected.,
As before motor or reciever fault?
 

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
Have you tried what Jeff suggested? Often sending to zero or reference position will sort out these problems.

If not, then a hard reset on the motor itself may be necessary.
 

Thor25rtn

Member
Joined
Jan 28, 2006
Messages
53
Reaction score
0
Points
0
Age
57
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
:) Hi All,
Re set the motor underneath and re set using USALs function.
Even better than before, needed very little tweaking to lock on.
Just need T-Rex cam for more channels!!!
 
Top