Multi LNB

Messages
4
Likes
0
#1
i have DXL 9100 receiver and i have 2 LNB's on 2 dish's,a while ago some body installed it for me and it was working fine,then i reseted the receiver into the factory sittings and one LNB only works,i also swiched the LNB's so i found out that on side of the swich works no matter the which LNB is conected to it.
sould i change any thing in my receiver sittings to make both LNB's work?
or do i have to buy a new swich?
thanks
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,698
Likes
1,286
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Yes, you need to go into LNB settings and allocate a letter to each LNB, the switch will be labelled A and B or 1 and 2. You of course need to make sure that you name the correct one and as you haven't indicated which satellites you are supposed to see, I cannot ofer any advice as to which LNB is which.


As a general rule of thumb, the more detailed information you provide, the more useful replies you will receive. :)
 
Top