Multiplexing Problem

Messages
3
Likes
0
My Satellite Setup
Zender DX1600 reciever
60cm Zender dish
.05 Univ. LNB
multiplexed with a 80 cm mesh dish and a .05 Univ. LNB

Toying with a commercial grade Scientific Atlanta PowerVu reciever.
My Location
Germany
#1
Hello,

I have a multiplexing problem. I recently added Astra 2. I have both dishes multiplexed into a diseqc (2 in- 1 out) coax multiplexor then into my reciever. When individually connected to my reciever I get all sat programing. But when I use the diseq multiplexor, I lose my Astra 2 feed. Astra 1 feeds are programmed for channels 1 to 135, Astra 2 are programmed for channels 684 to 830 or so. Any ideas why one feed would cancel the other?

BTW, I am in Germany near Kaiserslautern 49'N 7'E.:cool:
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,711
Likes
1,288
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
What have you set the LNBs at in the DiseqC menu of the receiver?
 
Messages
3
Likes
0
My Satellite Setup
Zender DX1600 reciever
60cm Zender dish
.05 Univ. LNB
multiplexed with a 80 cm mesh dish and a .05 Univ. LNB

Toying with a commercial grade Scientific Atlanta PowerVu reciever.
My Location
Germany
#3
Thanks Mate.

I did not activate my software Diseqc port assignments for multiple dishes. It works now. Over 250 channels of Blah!!! :eek: Super. Thanks again.:-rofl2
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,711
Likes
1,288
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#4
Glad you sorted it. :)
 
Top