DavMartinR
Member
- Joined
- Jun 30, 2005
- Messages
- 2
- Reaction score
- 0
- Points
- 0
- Age
- 58
- My Satellite Setup
- Lidli Comag party 11 system.
- My Location
- Pembrokeshire, UK
Hi
I'm looking for some advice. i recently purchase one of the Lidi Comag systems due to the fact that I think the German anlouge signal is also going to be switched off next year. I smiple connected the new LNB to the existing anoluge dish and there it was? Astra 1 with all the german channels. I then noticed that the reciever would accomodate more than just the one signal so I ordered two more LNB a bracket and a 4 way switch and to my suprise I could pick up Astra 1, Astra 2 and Hotbird. That was until last night when the reciever just froze on one channel with no picture. I turned the reciever off and on again but to no avail. I then left it off for some time then turned it back on where it can up with 'load' on the display? Has the reciever reset itself? and is downloading the software again? I left it for about an hour with no change. Does anybody now if there is a keying in sequence on the reciever to set it back to the default settings?? Or am I being to keen in setting it up with three LNBs??
Any help would be most apericiated
Cheers!
I'm looking for some advice. i recently purchase one of the Lidi Comag systems due to the fact that I think the German anlouge signal is also going to be switched off next year. I smiple connected the new LNB to the existing anoluge dish and there it was? Astra 1 with all the german channels. I then noticed that the reciever would accomodate more than just the one signal so I ordered two more LNB a bracket and a 4 way switch and to my suprise I could pick up Astra 1, Astra 2 and Hotbird. That was until last night when the reciever just froze on one channel with no picture. I turned the reciever off and on again but to no avail. I then left it off for some time then turned it back on where it can up with 'load' on the display? Has the reciever reset itself? and is downloading the software again? I left it for about an hour with no change. Does anybody now if there is a keying in sequence on the reciever to set it back to the default settings?? Or am I being to keen in setting it up with three LNBs??
Any help would be most apericiated
Cheers!