NEXUS-S DiSEqC problem

kostano

Member
Joined
Dec 13, 2004
Messages
1
Reaction score
0
Points
0
Age
56
Hi,

Have problem with DiSEqC.
I can move dish with STEP N WEST or EAST.
GOTO angle or stored position not work.
It worked from the beginning but stoped after fist week.
Another problem, started about same time:
To have synchronized signal from same transponders
it is required to reduce frequency by 250.

Any ideas?

I have WindowsXP, Hauppauge NEXUS-S 2.2, driver 2.17g,
Moteck SG2100 HH motor, ProgDVB, HispaDVB, etc.
 

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
For the transponder problem, check your LNB settings, if you have a universal LNB, they should be 9750 and 10600.

For the dish movement problem, check that you have your coordinates set correctly.
 

Missey

Regular Member
Joined
Jul 1, 2005
Messages
33
Reaction score
0
Points
0
Age
79
My Satellite Setup
Athlon 2400
Nexus-s
Progdvb
sg2100
My Location
Nova Scotia
I have the Same set up you have. About once a week I have to put put the SG2100 back to zero using the manual button and then re-set the motor using the re-set button. I used to program every thing from scratch, ProgDVB,DiseqcU,sat positions,ect, once a week but I soon found out all I had to do was put the motro back to zero and hit the re-set and every thing was ok for another week or so. I discovered that when the motor will not move on a channel change I can go into ProgDVB and use the positioner option and move the motor that way but in the end I still have to put the motor back to zero and hit reset. I have tried to fix this for the last 8 or 9 months, have read a lot of post's but never found an answer yet. If you have fixed yours, could you post it.I have just joined this site today an this is my first post.Missey
 
Top