Nokia 9800S first installation

comorc

Member
Joined
Aug 14, 2004
Messages
5
Reaction score
0
Points
0
Age
61
Hi,
I just bought a Nokia 9800S and am experiencing problems to instll it. I got the first installation menu for about 30 minutes and then the screen went black. I now have a code d200 on the nokia's screen.
Any idea how to get back to the first installation menu?
Needless to say that I didn't finish the installation.
Thanks
 

T24

Info Exec
Joined
Oct 9, 2002
Messages
566
Reaction score
5
Points
18
Reset the receiver:

How to do..

Using the remote control, switch off the Mediamaster 9800 S.
The time is shown on the display.
Now press and hold the Program+ button on the Mediamaster 9800 S.
Keep holding the Program+ button and press the Program- button as well.
Keep both pressed until "CUSt" appears on the display.
When you release the two buttons, a message (Pull The Cord) appears on the display.
Remove the power cord from the socket, wait five seconds and then plug it in again.
 

comorc

Member
Joined
Aug 14, 2004
Messages
5
Reaction score
0
Points
0
Age
61
Thanks for the advice, I tried that but it didn't work. On the Nokia's screen I have --.-- and that's it. I can't get to "CUSt" even when I press and hold the Program+ button on the remote control and then keeping holding the Program+ button and press the Program- button as well.
Other suggestion?
Thanks
 

T24

Info Exec
Joined
Oct 9, 2002
Messages
566
Reaction score
5
Points
18
try again M8,it will work,use the remote "only" to switch off the receiver.use the buttons on the front of the receiver.
 

comorc

Member
Joined
Aug 14, 2004
Messages
5
Reaction score
0
Points
0
Age
61
Thanks,
I tried again and was able to get the "CUSt" message using the front panel, but when I release the two buttons, the message "Pull The Cord" doesn't appears on the display but "d200" instead. Of course I tried to pull the cord anyway but when I put it back only "d200" comes back.
 

T24

Info Exec
Joined
Oct 9, 2002
Messages
566
Reaction score
5
Points
18
Try this.....

Remove the power cord from the socket.

2-Press ON/OFF button>keep presed.

3-reinsert the power cord.

4-When the display shows"----"release the ON/OFF button>press immediately the up

^ button "keep pressed" and prees the down button within 5 sec.

5-The display shows "CUST" and then> "pull the cord"

6-remove the power cord wait five seconds and then plug it in.

Good luck
 

comorc

Member
Joined
Aug 14, 2004
Messages
5
Reaction score
0
Points
0
Age
61
I tried but without sucess,
The display show CUSt blinking and then go back again to --:--
The message "Pull the cord" doesn't appear at all.
Thanks for your advice and time.
 
Top