caketin
Member
- Joined
- Aug 11, 2006
- Messages
- 11
- Reaction score
- 0
- Points
- 0
- Age
- 57
- My Satellite Setup
- Echostar ad3000ipva motorised setup
- My Location
- United Kingdom
Hi
I know this is an international Portuguese forum,but I am looking for expert help.
I have a rom 110 ac3 card.
I have been using rom110 studio v1.6
I am trying to set up my unlooper to glitch into the card.
I have used a resistance of 2.2k on the variable resistor unlooper and PSU at 9v but the response was bad.
The response was nothing like the one given in the rom110 studio document.
I tried to set up the resistor,and found 50ohms to give a good response.
Would it be better to leave the variable resistor at 2.2k and adjust the vcc start and vcc limit in the configuration menu?
Sorry for the post being in English.
Babelfish translator very bad in your language.
Theres not much point in me making a post in the English forums either.
I cant see many English posts in regards to mosc rom110 ac3.
Any help would be appreciated.
caketin
I know this is an international Portuguese forum,but I am looking for expert help.
I have a rom 110 ac3 card.
I have been using rom110 studio v1.6
I am trying to set up my unlooper to glitch into the card.
I have used a resistance of 2.2k on the variable resistor unlooper and PSU at 9v but the response was bad.
The response was nothing like the one given in the rom110 studio document.
I tried to set up the resistor,and found 50ohms to give a good response.
Would it be better to leave the variable resistor at 2.2k and adjust the vcc start and vcc limit in the configuration menu?
Sorry for the post being in English.
Babelfish translator very bad in your language.
Theres not much point in me making a post in the English forums either.
I cant see many English posts in regards to mosc rom110 ac3.
Any help would be appreciated.
caketin