Samsumg 9500 cant see MR

[pcm2]

Ive just got a Matrix Reloaded..but my Samsumg 9500 cant seem to see it. I dont even get an error message..it thinks the slot is empty.

What does this mean? Could the MR be blank? Is that possible? Ive tried both slots..and the cam is warm aftewards so power must be getting to it.

I have a smartcard programmer but not a CAM programmer.
Help, please!

 

[Pullet_Surprise]

Sammy doesn't like MR. The only way I got it to initialise after patching was:

1. Make sure sammy firmware 1.24 above (not multicas).
2. Insert cam, power off for 1 min, power up insert fun card a few times in and out of cam.

Only tried MR upto 1.081..just use emu now.

 

[titan64]

Hi
i just got a receiver and i have same prob
In command interface menu on receiver u need to choose
setup of card MR and after enter the new keys
(nagr. viaccess....) normaly it s works nice.

TItan64