SG-2100 Insanity and difficulties

K

kalamar

Guest
#1
If your SG-2100 motor goes insane, works,moves dish looks ok........BUT wont stop on any satellites properly ,check the mounting lug nuts up above the coax screw on connectors, just wiggle the coax jacks on the motor and see if they move,if so tighten them and realign center and it will stop where it is supposed to stop again. Worked for me !
 
K

kalamar

Guest
#2
So with nothing to do,I went outside and took a couple pics of my 110 Triax.
Sure is good beer !
 

Attachments

rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,727
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#3
Samual Adams? Haven't tried it Kalamar, where's it made?
 
K

kalamar

Guest
#5
Its made in the USA ,seen it on tv so much (hic) that I had to check it (hic) out.and it is very good beer. Made by the Boston beer company (says on "hic" bottle) its a dark type full flavor beer. mmmmmmmm mmmmmm good. % hic %
 
K

kalamar

Guest
#6
Here is the next job I must do today (hic)

Extra (hic) picture in case someone else wants some too (hic)
 

Attachments

rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,727
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#7
LOL, if I hadn't just eaten a chicken Kiev and wasn't on my eighth can of Carlsberg, I'd be over there like a shot. :)
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,727
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#8
Here's the SG-2100 I put up on Friday, with a Raven Gemini 70cm, nice compact little system. :)

The second picture is the Raven Gemini with two offset sats 13E, 19.2E and 28.2E.
 

Attachments

K

kalamar

Guest
#10
rolfw said:
Here's the SG-1200 I put up on Friday, with a Raven Gemini 70cm, nice compact little system. :)
good lookin system rolfw 76cm are about as good as any ,I use the motor on the 76 most of the time, When sig = 50+ you dont need anything bigger the digital pix wont care at all as long as the quality is up there.
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,727
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#11
I'm using a lot of them at the moment, reasonable price, great for a 15 degree spread (in fixed mode), very light to move for the DiseqC motor installation and the customer likes them, they don't stick out like a sore thumb. :)
 
BGonaSTICK

BGonaSTICK

Retired Moderator
Messages
5,145
Likes
0
My Satellite Setup
Dreambox 7000, Skystar2
My Location
Brighton
#12
LOL, I love this thread.


You have both lost the plot!

Nice wings...!
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,727
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#13
BGonaSTICK said:
LOL, I love this thread.


You have both lost the plot!

Nice wings...!
You are assuming that either of us had the plot to start off with. :D
 
K

kalamar

Guest
#14
The Chickens GONE ! so I took some more pictures, NOW the damn batteries are gone in the camera too so this will be all folks (hic hic) whatta day !
it was fun thou.
(hic)

thems 27" tvs not 27' tvs, you knew that didnt you ?
 

Attachments

rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,727
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#16
Carlsberg and Single Malt. :)
 
BGonaSTICK

BGonaSTICK

Retired Moderator
Messages
5,145
Likes
0
My Satellite Setup
Dreambox 7000, Skystar2
My Location
Brighton
#17
kalamar said:
The Chickens GONE ! so I took some more pictures, NOW the damn batteries are gone in the camera too so this will be all folks (hic hic) whatta day !
it was fun thou.
(hic)

thems 27" tvs not 27' tvs, you knew that didnt you ?
I tell you, if I ever catch the bloke that wrote all over your wall and floor, I'll give him a good kickin' for you!

attachment.php?attachmentid=949
 
S

Spooky

Lost In Space!
Messages
36
Likes
0
My Location
SOUTHAMPTON
#19
rolfw said:
Here's the SG-2100 I put up on Friday, with a Raven Gemini 70cm, nice compact little system. :)

The second picture is the Raven Gemini with two offset sats 13E, 19.2E and 28.2E.
Rolfw



I have just read through this thread and noticed a picture of one of the dishes that you installed. The second picture (the one with the two offset sats) shows the very same wall bracket that have just purchased.

Can you tell me exactly how you go about fixing that type of bracket i.e. do you bolt through to the block on the other side of the cavity or did you just screw the bracket to the brickwork?



Sorry if this sounds like a stupid question, but I’m a stupid person and I don’t want to bring down half the house as I am worried because my bracket looks like it will have a fair load on that back-plate!
 
Top