Technomate 5500 DAPCI setup

Messages
2
Likes
0
My Location
Sweden
#1
Is there anyone who can help? I have sent mail after mail to Technomate but they treat me like dust. Here´s my problem. I use 2 lnb´s, one for the ku-band and the other for the c-band. To switch between high and lowband on the ku-lnb it use 13/18 volt. Polarity is set with a mech. polarotor. To switch between the lnb:s I use a diSec. Can I use this concept with the TM 5500 DAPCI? I ask because I can´t find the alternative for polarotor in the inst. menu.
Thankfull for any help.
 

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,137
Likes
5,600
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#2
I take it the 13/18 use for low , high band is because the Ku LNB is a full band type

Does the technomate have polariser connections on the rear of the receiver ? If so then in the C band menu there should be a setting for adjustment.

Its very rare that any manufacturer caters for mechanical polarisers nowadays, especially since some C band LNBs now use 13/18 for the polarity settings.
 
Messages
2
Likes
0
My Location
Sweden
#3
Yes, the receiver has connections for polarotor. But there isn´t any specific c-band menu.
 
Top