Technomate 5500 DAPCI setup

[maxim]

Is there anyone who can help? I have sent mail after mail to Technomate but they treat me like dust. Here´s my problem. I use 2 lnb´s, one for the ku-band and the other for the c-band. To switch between high and lowband on the ku-lnb it use 13/18 volt. Polarity is set with a mech. polarotor. To switch between the lnb:s I use a diSec. Can I use this concept with the TM 5500 DAPCI? I ask because I can´t find the alternative for polarotor in the inst. menu.
Thankfull for any help.

 

[Channel Hopper]

I take it the 13/18 use for low , high band is because the Ku LNB is a full band type

Does the technomate have polariser connections on the rear of the receiver ? If so then in the C band menu there should be a setting for adjustment.

Its very rare that any manufacturer caters for mechanical polarisers nowadays, especially since some C band LNBs now use 13/18 for the polarity settings.

 

[maxim]

Yes, the receiver has connections for polarotor. But there isn´t any specific c-band menu.