damhy
Regular Member
- Joined
- Jul 24, 2004
- Messages
- 266
- Reaction score
- 0
- Points
- 16
- Age
- 42
- My Location
- Kent
I was wondering the best way to have a two receiver motorised setup. The diagram I have drawn below shows the basis of what I think the layout needs to be like.
Where I have the question mark I think I'ld require some kind of switch that would, when switched one way, take input1 -> output1 and input2 -> output2. Then when switched the otherway would connect in1 -> out2 and in2 -> out1. If this was possible then you could make a selection on which satellite had control of the motor. But because it is a dual LNB, you could get both V and H channels on both receivers at the same time.
Dont know how you guys think this would work, or if there is even a switch for what I want to do. But any ideas greatly appreciated. Or obviously alternative solutions.
Thanks
Where I have the question mark I think I'ld require some kind of switch that would, when switched one way, take input1 -> output1 and input2 -> output2. Then when switched the otherway would connect in1 -> out2 and in2 -> out1. If this was possible then you could make a selection on which satellite had control of the motor. But because it is a dual LNB, you could get both V and H channels on both receivers at the same time.
Dont know how you guys think this would work, or if there is even a switch for what I want to do. But any ideas greatly appreciated. Or obviously alternative solutions.
Thanks